Addonics Technologies HDU11SITDR User Manual download pdf (Page 2)

I. Installing Drive into the HDD Duplicator

For installing a hard drive on the various enclosures that come with the HDD duplicator, refer to

the bundled enclosure installation guides.

Step 1

Once the hard drive is installed on the drive enclosure, slide in the Source drive into the drive bay. Push

down the handle and using the key provided, turn the key lock to the Lock position. This will secure the

drive and turn on the power to the hard drive.

Step 2

Slide in the Target drive into the drive bay. Push down the handle and using the key provided, turn the key

lock to the Lock position. This will secure the drive and turn on the power to the hard drive.

II. Connecting the Power Cable and Powering On

a. Connect the power cord provided from the wall outlet to the back of the tower.

b. A main power switch is located at the back of the tower. Turn the switch on. Another auxiliary

switch is located on the front of the tower.

c. Push the auxiliary switch button to turn on the HDD duplicator.

III. The Duplicator Panel

There are four buttons and an LCD on the panel of HDD Duplicator.

1 – LCD shows a function or a message.

2 – it is used to scroll up function menus.

3 – it is used to scroll down function menus.

4 – it is used to execute a function.

5 – it is used to cancel a function.

IV. Duplicating a drive

When the duplicator powers on, it initializes and goes through the steps below

Shows the firmware version Initialize SDRAM's status..

Detect Drives' status. Shows the first function:

Copy HDD copies data directly from the source hard disk to the target hard disk.

Press ENT button to begin copy. The system will auto-detect the hard disks and show the following info

on the LCD.

The LCD will show the following info during the copying process: remaining time, completed percentage.

The copy speed, capacity and time will vary depending on the source hard disk. Once the copying

process is complete the LCD will display the following results.

The complete user manual of the HDD Duplicator Panel can found in the Driver Disk under User Guides

or can be downloaded from http://www.addonics.com/support/user_guides/

HD Duplicator

1-1 Ver:

Initialize SDRAM

Detect Drives

Copy-36MBs 0%

235.7GB 1:48

Copy HD

OK:

1.Copy HD

ENT

ESC

Duplicator Panel

1 2

Comments to this Manuals

No comments

Addonics Technologies HDU11SITDR User Manual Page 2

Comments to this Manuals