Addonics Technologies HDUSI325 User's Guide download pdf (Page 3)

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/

I. Installing drive into the HDD Duplicator

Note: Make sure that the capacity of the target hard disk is equal

or larger than the source hard disk.

For example, on the label of the hard drives, it might identify both

drives as 80GB but the actual size differs. And when this type of

drives are used on the HDD duplicator, when you start

duplicating, you will receive a “Target Not Ready” error. To

resolve this issue, you need to decrease the drive size of the

source drive. To do this, navigate to: 6.Setup > 6.2Copy Size and

use the button arrows to decrease the drive size of the source

drive by increments of 1%.

For installing a hard drive on the various enclosures that

come with the HDD

duplicator,

refer to the bundled

enclosure installation guides.

Step 1

Once the hard drive is installed on the drive enclosure, slide in

the Source drive into the drive bay. Push down the handle and

using the key provided, turn the key lock to the Lock position.

This will secure the drive and turn on the power to the hard drive.

Step 2

Slide in the Target drive into the drive bay. Push down the

handle and using the key provided, turn the key lock to the Lock

position. This will secure the drive and turn on the power to the

hard drive.

II. Connecting the power cable and powering on

a. Connect the power cord provided from the wall

outlet

to the

back of the tower.

b. A main power switch is located at the back of the tower. Turn

the switch on. Another auxiliary switch is located on the front

of the tower.

c. Push the auxiliary switch button to turn on the HDD

duplicator.

Basic Instructions

1 2 3 4 5 6 7 8 ... 16 17

No comments

Addonics Technologies HDUSI325 User's Guide Page 3