Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk.
For example, on the label of the hard drives, it might identify both drives as 80GB but the actual size
differs. And when this type of drives are used on the HDD duplicator, when you start duplicating, you will
receive a “Target Not Ready” error. To resolve this issue, you need to decrease the drive size of the
source drive. To do this, navigate to: 6.Setup > 6.2Copy Size and use the button arrows to decrease the
drive size of the source drive by increments of 1%.
T E C H N O L O G I E S
User Guide
1:11 HDD Duplicator PRO
(HDU11SITDR)
Technical Support
If you need any assistance to get your unit functioning properly, please have your
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
v6.1.11
ENT
ESC
Duplicator Panel
Source Drive Bay
Target Drive Bay 6 - 11
Target Drive Bay 1 - 5
Power Switch
Comments to this Manuals